I was up early on Friday and soon after breakfast I began working in the small lounge once more. It was 8.30 and I was ready to go. First job was to apply the priming coat to the skirting board, door frame and door. The window and the fireplace were already done earlier. It took some time to get around the room but the finish didn’t need to be perfect as the paint was only a primer and in this case was being used to blot-out the mahogany stain too. All the stain has now gone. Next job was to strip off the wall paper which I had not been able to remove while it was dry. Now some people might use a steam pad to wet the wall paper but I use cold water applied with a brush and while the water is sinking through the surface in one place I use the scraper or even fingers to remove the paper elsewhere. Most of the time it comes off, well falls off in sheets! The only difficult part is where the top vinyl layer has not been stripped off first which then means the process has to be done twice. As I had already stripped much of the paper from the wall when it was dry there was little of the top layer left.
That work took me into the afternoon, with a break for lunch and then I decided to apply the first coat of white gloss paint to the window frame. It was surprisingly easy and could almost pass with just the one coat but it will get two.
You may notice that the carpet has gone but not the underlay. When I purchase a new carpet the underlay will be replaced too though the existing one is quite serviceable apart from a small area near the door which I think was water damaged when a liquid had been spilled and then washed off with water. It wasn’t replaced when we had the last carpet change over fifteen years ago so having a new one is probably a better idea. It was four o’clock and I was finished for the day. I am happy with the progress and am enjoying doing the work.