Carpentry and stuff

Standard

I have always enjoyed working with wood, it is one of those materials which is easy to work with though it is unforgiving, make a mistake and it isn’t easily undone. I have made a few mistakes in the past when working with wood as I am sure many have but it is a rewarding experience making things in wood. My latest little project is manufacturing a wooden gate and installing it at the side of the house. My readers will by now have seen my progress with the brickwork if they’ve followed my recent posts. On Thursday (10 th) I began working with the wood and my first task was to cut and fit the two wooden posts for each side of the gate opening…..

The one on the right has to support the gate itself so I used large ‘Rawlbolts’  to secure it to the brick wall. Here is a picture of a rawlbolt for anyone who doesn’t know what they are,,,

As the bolt is tightened it draws the nut (on the right-hand end) into the body which expands inside the hole in which it is fitted. The bolt obviously passes through the timber first! The post on the left has no weight to carry and therefore I used long screws instead. I must remember to clean off the dried mortar on the wall on the right where I had been filling in some holes after installing the posts.The posts themselves do not stand directly on the ground so that they will resist rotting  when it rains. Wood standing on the ground will soak up water and eventually get wet rot. The timber was purchased pre-treated against the weather but I have given it more coats of weather resisting treatment too. After lunch I began work on constructing the gate itself and got this far with it before stopping for the day at five o’clock….

I have it standing in the garage as I write this. There is more work to do on it yet before I hang it in position though. Hopefully I can finish the work soon, it all depends upon other things, not least of all the weather.

Shirley Anne

Advertisements

2 responses