I don’t profess to be perfect in anything I undertake but I make a determined effort in that direction. I take pride in my work and I believe I have every right to do so, the results speak for themselves. Yes I make mistakes and have botched up one or two things in the past but I have never left them that way, I make another attempt until I get it right. I always say if a job is worth doing it is worth doing right first time, it is just as easy to do things correctly as it is to do them incorrectly. The added advantage is not having to return to put things right. I have found lately that not everyone I have employed takes the same pride in their work and I suspect have not been competent in the first place.
A few months ago now I had purchased new curtains (drapes) for a room I was refurbishing and redecorating and waited eagerly for them to be fitted once my work had finished. On the appointed day the fitter arrived and began the work. I felt a little apprehensive as I didn’t think he was that competent. My feelings proved to be right for I had to intervene in what he was doing else end up with a shoddy job. It was all to do with the way the curtain rail was affixed to the wooden window surround. With a little help from myself he got the job done to my satisfaction. I should have arranged to fit them myself on reflection. More recently E’s nephew botched up the job I had employed him to do, raising part of the garage roof. It leaked because he hadn’t done it the way I had asked. I expect a builder to know what he is doing and not have to take instruction from me. I am not a builder. He had to return and do it again. When the fitters came to install the new garage door they went at it like a bull at a gate. I noticed the mistakes they were making along the way. It should have been a case of more haste less speed but it wasn’t. Their workmanship left a lot to be desired I have to say and I cringed at some of the work they had done, not enough screws where there should really have been, cables left dangling, no bushing of holes where cables passed through and so on. They weren’t electricians or engineers and it showed. They drilled access holes in the plastic body of the control unit using a drill bit only suitable for drilling wood! The bit ‘tore’ at the plastic which began to split. I wouldn’t mind but they had the proper drill bits for the job! I did some remedial work once they had departed. They were supposed to return to fit an alarm and to finish filling gaps with silicone but after a couple of weeks we had to get in touch with the company to remind them. The company sent another ‘engineer’ who fitted the alarm and filled in with silicone all where it was necessary. When he left I looked more closely at his work. I wasn’t impressed. I had installed a large wooden board to accommodate the fixing of the control equipment but this guy chose to screw the alarm unit to the brick wall above it without using wall plugs! Furthermore he had wired the unit into the main control panel passing the wires beneath the top cover housing the light. In the process he had severed the wires! I moved the alarm down to the board and fixed it there. I had to effect a repair to the wiring and cut a slot in the light cover so the wire would not be severed again. I have no idea why he had chosen to install the alarm as he did nor why he passed the wire beneath the light cover especially as there was plenty of space on the board and easier access to the wiring terminals from beneath the unit. He spoiled what was otherwise a good installation on his behalf.